Use as a hot/warm application

Warning: Some medical conditions may require advice from a health professional before application.

Take extra care when using with children, the elderly, disabled, ill and sleeping recipients.

If ingested seek medical advice.

 Body Cooling Vest

  • Make sure vest is in gel (activated state).
  • Place vest inside out into microwave for approximately 1 minute either side. If vest is not hot enough continue heating in 30 second increments until vest is at required temperature.
  • Always check vest against skin before wearing to avoid burns.
  • Vest can also be placed in reuseable zip top bag and placed in hot water for 3 minutes or longer. 
                                  

 Body Wraps

  • Make sure vest is in gel (activated state).
  • Place in microwave with gel pockets facing up for 30 second intervals (it may be necessary to fold wrap in half for even heating).
  • Continue heating to required temperature in 30 second increments.
  • Always check product against skin before applying to avoid burns.

OR

    • Soak in desired water temperature for 2 minutes. Remove from water, gently squeeze and towel dry. 
    • Check the product against skin before applying. If comfortable apply to body part.  If excessively hot, allow to cool.

     

For further information contact Arctic Heat Products at research@arcticheat.com.au.

 

[ Back to top ]


 

<<<<< Copyright © 2000 Arctic Heat all rights reserved >>>>>